Filter
Top Products
BIOS Setup Utility SY-6BA+ III
60
3-8.5 Onboard Parallel Ports
Onboard Parallel
Ports
Setting Description Note
378H/IRQ7 Default
3BCH/IRQ7
Onboard Parallel
Port
278H/IRQ5
Choose the printer I/O
address.
ECP/EPP Default
SPP
ECP
Parallel Port Mode
EPP/SPP
The mode depends on
your external device that
connects to this port.
If [Parallel Port Mode] is set to [ECP] mode
3 Choose DMA3 Default
ECP Mode use
DMA
1 Choose DMA1
If [Parallel Port Mode] is set to [EPP] mode
EPP 1.9 Select EPP port type 1.9
EPP Mode Select
EPP 1.7 Select EPP port type 1.7 Default
On The system will switch on
when power comes back
after a power failure.
Off The system will remain
off when power comes
back after a power
failure.
Default
PWRON After
PWR-Fail
Former-sts The system will return to
the state it was in before
the power failure when
power returns. (i.e: If the
system was on, it will
switch on again, if it was
off, it will remain off)