SOYO SY-6BA+ III Computer Hardware User Manual


 
Hardware Setup SY-6BA+ III
28
Step 20. Power Off
There are two possible ways to turn off the system:
1. Use the Shutdown command in the Start Menu of Windows
95/98 to turn off your computer.
2. Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-
button for less than 4 seconds, then your system will enter into
Suspend Mode.
Note on Over-clocking Capability
The SY-6BA+ III provides over-clocking capability. Due to the over-
clocking setting your system may fail to boot up or hang during run
time. Please perform the following steps to recover your system
from the abnormal situation :
1. Turn off system power (If you use an ATX power supply, and
depending on your system, you may have to press the power
button for more than 4 seconds to shut down the system.)
2. Set the JP8 to short if you use a FSB 66MHz CPU
3. Press and hold down the <Insert> key while turning on the
system power. Keep holding down the <Insert> key until you see
the message of the CPU type and frequency shown on the screen.
4. Press the <Del> key during the system diagnostic checks to
enter the Award BIOS Setup program.
5. Select [SOYO COMBO SETUP] and move the cursor to the
[CPU Frequency] field to set the proper working frequency.
6. Select [Save & Exit SETUP] and press <Enter> to save the
new configuration to the CMOS memory, and continue the boot
sequence.
Note: SOYO does not guarantee system stability if the user
over clocks the system. Any malfunctions due to over-clocking
are not covered by the warranty.