Filter
Top Products
Hardware Setup SY-6BA+ III
23
Step 17. Power-On by Keyboard Jumper (JP10)
You can choose to enable the Power-On by Keyboard function by
shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable
this function.
Power-On by
Keyboard
Enable Disable
JP10 Setting
Short pin 1-2 to enable
the Power-On by
Keyboard function.
Short pin 2-3 and the
Power-On by Keyboard
function is disabled.
Note: When using the Power-On by Keyboard function,
please make sure the ATX power supply can take at least
720mA load on the 5V Standby lead (5VSB) to meet the
standard ATX specification.
Step 18. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
3
2
1
3
2
1