Filter
Top Products
Hardware Installation SY-K7ADA
25
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the
Motherboard. Pushing the Reset button on the front panel will cause the
system to restart the boot-up sequence.
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker header on
the Motherboard.
4. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED
header on the Motherboard. This will cause the LED to light up when an
IDE (HDD, CD-ROM) device is active.
Speaker Pin Assignment
+
_
Power
Speaker out
NC NC
Pin17 Pin18 Pin19 Pin20
HDD LED Pin Assignment
+
_
Power
HDD LED
Pin9 Pin10
Reset Pin Assignment
Power RSTGND
Pin1 Pin2