Filter
Top Products
BIOS Setup Utility SY-K7ADA
43
My PCI VGA card works fine with my system, but when I put in a
new AGP card, it does not give me any video. Is my AGP slot bad?
This is a common problem with AGP video cards. The reason is that your
AGP card did not get seated into the AGP slot fully and firmly. Please
push your AGP card down into the socket real hard, it should snap twice.
You may have to unscrew the AGP card to allow the card to go further
down. Do take care not to damage the card by using too much force.
I get distorted video my AGP card right after I save my bios. Why is
that?
The cause is likely that your AGP card is not running at the correct bus
speed. To fix this, please clear the CMOS ALi JP5 and if it still does not
work, please upgrade your motherboard bios to the latest version.
BIOS Issues
Where can I find the BIOS revision of my mainboard?
It will be displayed on the up-left corner on the screen during boot-up. It
will show as your board type followed by the revision number, such as
5EH_2CA1 (meaning revision 2CA1 for the SY-5EH board) or 6BA+
IV_2AA2 which means SY-6BA+ IV motherboard with 2AA2 bios.
Where can I find the latest BIOS of my motherboard?
Please go to the technical support page of one of the SOYO websites
(Taiwan: www.soyo.com.tw), and look up your motherboard to find
the latest BIOS revision.
Hard disk, floppy drive, CD-ROM etc
When I boot up my new computer I got "floppy boot failure" and the
LED on the floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy
drive side (don't trust the "key lock" or "notch") and use the end-connector
of the cable (don't use middle one).
Modem issues
I get an "I/O Conflict" message when I turn on my system and I can
not get my modem to work