Filter
Top Products
SPECTRA SERIES 17
4.1 ACCESS CODE LENGTH
Section [127]: System Options
Option [2] OFF = 6-Digit Access Codes
Option [2] ON = 4-Digit Access Codes (default)
All access codes can be set to lengths of either 4- or 6-digits. When the 4-digit option is selected, entering a 4-digit
code will allow access. Using the 6-digit option, entering 6 digits is required to allow access.
If the Access Code Length is changed from four digits to six digits when access codes have already
been programmed, the control panel will automatically add the last 2 digits by using the first 2 digits.
For example, if the access code is 1234 and you switch to 6 digits, the code will become 123412. Be
sure to verify the access codes after switching from 4-digit access codes to 6-digit codes. When
switching from six digits to four digits, the control panel will simply remove the final two digits of the
access code. For example, 123456 will become 1234.
4.2 INSTALLER CODE (Default: 000000 OR 0000)
The Installer Code is used to enter the control panel's programming mode (see page 13), which allows you to
program all the features, options and commands of the control panel. The Installer Code can be 4- or 6-digits in
length (see above) where each digit can be any value from 0 to 9. The Installer Code cannot be used to program
Master Code 1, Master Code 2 or User Access Codes. To program the Installer Code press:
[
ENTER] + [CURRENT INSTALLER CODE] + [281] + new 4- or 6-digit Installer Code
4.3 SYSTEM MASTER CODE (Default: 123456 OR 1234)
The Installer Code can be used to program the System Master Code. With the System Master Code a user can use
any arming method and can program any User Access Code, but not the User Code Options. The System Master
Code can be 4 or 6 digits in length (see section 4.1), where each digit can be any digit from 0 to 9. To change the
System Master Code press:
[
ENTER] + [INSTALLER CODE] + [301] + new 4- or 6-digit System Master Code
4.4 USER CODE OPTIONS
Sections [302] to [348]: Options [1] to [7]
The User Code Options define which arming methods each user can use to arm or disarm the system. Regardless
of these settings, all users can Regular Arm assigned partitions and all users except those with the Arm Only option
can disarm an assigned partition, regardless of how it is armed. Select one or more of the options described on the
following pages for each User Access Code, where sections [302] to [348] represent User Access Codes 002 to
048. For information on how User Access Codes are programmed, please refer to page 51.
4.4.1 PARTITION 1 ASSIGNMENT
Sections [302] to [348]: User Codes 002 to 048
Option [1] OFF = Deny access to partition 1
Option [1] ON = User code has access to partition 1 (default)
If Partitioned (see page 43), user codes with this option enabled can arm and disarm partition 1.
If the system is not partitioned, you must assign partition 1 to the User Access Code.
Otherwise, the User Access Code will be considered disabled.
4.4.2 PARTITION 2 ASSIGNMENT
Sections [302] to [348]: User Codes 002 to 048
Option [2] OFF = Deny access to partition 2 (default)
Option [2] ON = User code has access to partition 2
If the system is partitioned (see page 43), user codes with this option enabled can arm and disarm partition
2. If the system is not partitioned, the control panel ignores this option.