Filter
Top Products
42 User Setup Utility
When you start the User Setup Utility, it reads and displays the last settings
that were sent to the printer by the utility.
Note:
The utility does not read the settings from the printer. It reads the settings from
a file that was created the last time the utility was run, which are stored on your
computer’s hard disk. If the EDS settings have been changed using the
printer’s control panel, those control panel settings will not be shown by the
utility, and they will be replaced by the current User Setup Utility settings if
you specify that current settings should be sent to the printer (page 45) when
you exit the utility.
❏ Now you can use the User Setup Utility to make the setup changes you
want.
You can press the F1 function key at any time to access on-screen help for
the setup utility.
Changing the General, Font, Paper and Adjust Settings
The following are basic operations to change settings in the General, Font,
Paper and Adjust windows.
To select a window
❏ Click on the name of the window you want to select (General, Font,
Paper, Adjust, Port) by clicking on its name at the top of your computer’s
screen. When you do, the corresponding window appears on the screen.
You can also select a window by pressing a function key from F4 to F8.
General
Standard
*
Emulation
Input Buffer
*
RAM usage
Disabled
*
Quiet mode
Bi-direction
*
Graphic Direction
Long
*
CR Centering Position
Help
F1
Exit
F2
File
F3
Font
F5
Paper
F6
Adjust
F7
Port
F8
General
F4