Filter
Top Products
33
Chapter 4: Using the Printer with MS-DOS
This chapter contains information about how to use the printer with applications
software running under MS-DOS. In this chapter, you will learn about:
❏ How to set up for printing with MS-DOS
Setting up for printing with MS-DOS
To print from an application running under MS-DOS, you must first select the
printer from within the application. Typically, the program will feature an
INSTALL or SETUP command for selection of printers. Refer to the manual
for the application you are using for details on how to select a printer for it.
Note:
Remember that you must select a printer for each individual application before
you can print from it.
❏ Start up the application and use the correct procedure for that application to
select a printer. The following is a list of printers that can be used. If your
application lists more than one of these, select the printer that is nearest to
the top of this list. You should also use the EDS mode or User Setup Utility
to select Standard emulation (page 26).
* Does not support color printing.
Star LC-1011C / LC-100+ Colour
Star NX-1040 / LC-100 Colour
Star NX-1020 / LC-200 Colour
Epson EX-800
Epson FX-850*
Star NX-1000 / LC-10 Colour