Star Micronics RS232 Printer User Manual


 
– 21 –
STAR MODE
8. CONTROL CODES/STAR MODE
8-1. Star Mode Command Summary
The details of each command are shown in the following sections.
Commands to Select Characters
Control codes
Hexadecimal
Function Page
codes
<ESC> “R” n 1B 52 n Select international character set 25
<ESC> “/” “1” 1B 2F 31
Select slash zero 25
<ESC> “/” <1> 1B 2F 01
<ESC> “/” “0” 1B 2F 30
Select normal zero 25
<ESC> “/” <0> 1B 2F 00
<ESC> “b” n1 n2 n3 n4 1B 62 n1 n2 n3 n4
Select bar code printing 26
d1 ... <RS> d1 ... 1E
<ESC> “M” 1B 4D Select 12-dot pitch printing 30
<ESC> “p” 1B 70 Select 14-dot pitch printing 30
<ESC> “P” 1B 50 Select 15-dot pitch printing 30
<ESC> “:” 1B 3A Select 16-dot pitch printing 30
<ESC> <SP> n 1B 20 n Set character spacing 30
<SO> 0E Sets the printing magnified double in
31
character width.
<DC4> 14 Resets the printing magnified in
31
character width.
<ESC> “W” n 1B 57 n
Sets the magnification rate in character width.
31
<ESC> <SO> 1B 0E Sets the printing magnified double in
31
character height.
<ESC> <DC4> 1B 14 Resets the printing magnified in character
31
height.
<ESC> “h” n 1B 68 n
Sets the magnification rate in character height
.32
<ESC> “i” n1 n2 1B 69 n1 n2 Sets the magnification rates in character
32
width and height.
<ESC> “
” “1” 1B 2D 31
Select underlining 32
<ESC> “
” <1> 1B 2D 01
<ESC>“
” “0” 1B 2D 30
Cancel underlining 32
<ESC> “
” <0> 1B 2D 00
<ESC> “
_
” “1” 1B 5F 31
Select upperlining 33
<ESC> “
_
” <1> 1B 5F 01
<ESC> “
_
” “0” 1B 5F 30
Cancel upperlining 33
<ESC> “
_
” <0> 1B 5F 00