Filter
Top Products
– 52 –
STAR MODE
Commands to Control Auto Cutter
FUNCTION
Full-cut command to the auto cutter
CODE <ESC> “d” “0” or <ESC> “d” <0>
HEX
1B 64 30 or 1B 64 00
REMARKS
Cuts the paper fully when memory switch 2-C is set to 0. If memory
switch 2-C is set to 1, the paper is fed to 18 mm and cut fully.
When auto cutter is invalid, this command is not valid.
FUNCTION
Partial-cut command to the auto cutter
CODE <ESC> “d” “1” or <ESC> “d” <1>
HEX
1B 64 31 or 1B 64 01
REMARKS
Cuts the paper partially when memory switch 2-C is set to 0. If
memory switch 2-C is set to 1, the paper is fed to 18 mm and cut
partially.