Filter
Top Products
Preparing for Installation 1-13
1
3. Extend the stabilizer bar fully from the bottom of the cabinet.
See Figure 1-11.
4. Screw the two stabilizer bar levelling pads down until they are 1/8- to
1/4-inch (three to six millimeters) above the floor.
Make sure both pads are at equal heights above the floor. This clearance
allows an extended stabilizer bar to stop the cabinet if it should begin to tilt.
Figure 1-10 Rear Screen, Levelling Wrench, Kick Panel, and Levelling Pad
5. Slide the stabilizer bar into the cabinet.
Warning – Always extend the stabilizer bar before pulling the disk drive trays
out for servicing.
6. Adjust the four levelling pads on the cabinet frame. The four pads should
press against the floor so that the cabinet does not move.
To adjust levelling pads on the cabinet rear, you may have to remove the
kick panel. Two captive screws attach the panel to the cabinet (Figure 1-10).
Rear screen
Kick panel
Levelling pad
(1 of 6)
!