Filter
Top Products
6-6
SuperWorkstation 7047A-73/7047A-T User's Manual
Installing/Removing SAS/SATA Drives
The SAS/SATA drive carriers are all easily accessible at the front of the chassis.
These drives are hot-swappable, meaning they can be removed and installed with-
out powering down the system.
1. Open the front bezel then push the release button located beside the drive
LEDs.
2. Swing the handle fully out and then use it to pull the unit straight out.
Note: Your operating system must have RAID support to enable the hot-swap
capability of the SAS/SATA drives.
Mounting a SAS/SATA drive in a Drive Carrier
The SAS/SATA drive carriers help to promote proper airfl ow for the system. For this
reason, even carriers without SAS/SATA drives must remain in the chassis.
1. Insert the drive into the carrier with the printed circuit board side facing down
so that the mounting holes align with those in the carrier.
2. Secure the drive to the carrier with four screws (see Figure 6-5).
6-4 Drive Bay Installation
A total of six SAS or SATA drives may be housed in the SC743TQ-1200B-SQ chas-
sis. The drive IDs are preconfi gured as 0 through 7 in order from bottom to top (or
from left to right if rackmounted). A bezel covers the drive area but does not need
to be removed to access the drives; simply swing open the bezel. If you wish to
remove the bezel piece, push on the three tabs on the inside of the left lip of the
front chassis cover. Then slightly swing out the same (left) side of the cover - about
½ inch only. Remove by pushing on the open side of the cover to remove it from
the chassis (do not try to swing or pull it straight out after opening the left side).
Regardless of how many SAS/SATA drives are installed, all drive carriers
must remain in the drive bays to promote proper airfl ow.
!
!
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the
Supermicro Web site at http://www.supermicro.com/products/nfo/storage.
cfm