Filter
Top Products
SysKonnect SK-98xx V2.0 Gigabit Ethernet Adapter
IBM AIX 29
9. Select SKGE.
10. Select A
CTIONS > INSTALL (ANALYSIS).
11. When the analysis is finished, confirm with O
K.
12. Click Y
ES.
The following message will be displayed: “
The system will be rebooted as
soon as Installation is complete. Do you still wish to start
Installation?
”.
13. Confirm with Y
ES.
14. After the installation is completed, click D
ONE.
15. Click O
K to reboot.
The driver has been installed and the network adapter can now be configured.
Use the command line To install the driver from the command line, proceed as follows:
1. After you have installed the adapter in your computer, boot the HP-UX system (for
details, see chapter 2 "Installation of the Network Adapter").
2. Execute the following command from a shell:
swinstall -s <package file> -x autoreboot=true skge
The package file must include the full path to the package.
3. Press <Enter>.
The system will install the package and then reboot.
For more information, refer to the corresponding readme file.
IBM AIX
The drivers support the SysKonnect SK-98xx family on AIX 4.3.3, AIX 5.1, and AIX 5.2 oper-
ating systems. For correct driver access, the corresponding Ethernet protocol interface must
be installed for TCP/IP configuration. The drivers can not be installed on machines with less
than 256 MB memory. We recommend to install the drivers on machines offering at least 512
MB memory.
There are two possibilities to install the driver packages on IBM AIX:
• Automatic installation with “smitty” and the configuration manager
• Manual installation with “smitty”
The installation follows the general guidelines of IBM AIX 4.3 and 5.1/5.2 operating systems
for software package installation of third party device drivers.
Driver packages downloaded from our web site are available in a compressed format (.Z
files). The downloaded package has to be uncompressed before installation.
Uncompress the
driver
To uncompress the downloaded driver package, proceed as follows:
1. Go to the directory where the compressed driver package <filename>.pck.Z is located,
e.g. sk98a4x3p.pck.Z for AIX 4.3.3.
2. Uncompress the file with the following command:
uncompress <filename>.pck.Z
The uncompressed driver package has the format <filename>.pck and is ready for instal-
lation.
Install from CD-ROM
on AIX 4.3.3
If the driver is to be installed from CD-ROM on an AIX 4.3.3 operating system, the following
steps have to be executed prior to the driver installation:
1. Boot AIX 4.3.3.
2. Login as “root”.
3. Insert the SysKonnect installation CD-ROM into your CD-ROM drive.