Filter
Top Products
TANDBERG 3G Gateway Data port Command Interface User Guide
4.1.2. Command types
The commands can be divided into three major classes:
• Parameter Configuration Commands, Xconf.
• Status Commands, Xstat.
• User Commands, Xcom.
Parameter Configuration Commands
are commands that set a system parameter to a specific value. E.g.: The
command Xconf telnet mode: "on" enables telnet access on the 3G Gateway. If the command is
syntactically correct the 3G Gateway returns OK, otherwise the 3G Gateway returns ERROR. An example
is shown below (the user input is shown in bold).
Xconf telnet mode: "on"
OK
When issuing a Parameter Setting Command without a parameter, the 3G Gateway will return the command
with the current setting. E.g.:
Xconf telnet mode
*c xConfiguration Telnet Mode: On
OK
Status Commands
are commands that list different sets of system parameters. Status commands are
automatically called when corresponding parameters are being changed.
User Commands
are commands that allow users to configure operational parameters, like option keys,
service and dial plan entry manipulations, disk operations and system reboot.
4.2. The commands
The commands are divided into five groups: System Configuration Commands, General 3G Gateway
Commands, System Status Commands, Debug Commands and Special Commands.
D1320203 8