Filter
Top Products
TANDBERG Gatekeeper/Border Controller API User Guide
D14172.01 page 42 of 84
Traversal UDPProbe RetryCount: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the number of attempts at re-
establishing a failed UDP channel.
Traversal UDPProbe KeepAliveInterval: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the interval with which a UDP
channel should be refreshed.
Traversal TCPProbe RetryInterval: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the interval with which a failed
attempt to establish a TCP channel should be repeated.
Traversal TCPProbe RetryCount: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the number of attempts at re-
establishing a failed TCP channel.
Traversal TCPProbe KeepAliveInterval: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the interval with which a TCP
channel should be refreshed.
Traversal Media RTP Port: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the UDP port to which media
should be sent.
Traversal Media RTCP Port: <1..65534>
(Applies only if the system is a Border Controller.) Specifies the UDP port to which media
control information should be sent.
Traversal AssentEnabled: <On/Off>
(Applies only if the system is a Border Controller.) Determines whether or not the Border
Controller will allow firewall traversal using TANDBERG's proprietary Assent protocol.
Traversal H46018Enabled: <On/Off>
(Applies only if the system is a Border Controller.) Determines whether or not the Border
Controller will allow firewall traversal using the ITU H.460.18/19 protocols.
Traversal Preference: <Assent/H46018>
(Applies only if the system is a Border Controller.) Determines which of the two protocols to
use when given a choice.
Traversal H46019Demultiplexing: <On/Off>
(Applies only if the system is a Border Controller.) H.460.19 optionally allows all media to be
sent to the same ports on the Border Controller and demultiplexed there.
Authentication Mode: <On/Off>
Determines whether or not to enforce authentication for registrations.
Authentication UserName: <S: 0, 25>
Specifies the user name to be used by the system when authenticating with another system.
Authentication Password: <S: 0, 25>
Specifies the password to be used by the system when authenticating with another system.