Filter
Top Products
TANDBERG Gatekeeper/Border Controller API User Guide
D14172.01 page 48 of 84
4 API - Commands
This section gives an overview of the supported system Commands.
All examples are presented using the standard XACLI format.
4.1 command.xml – xcommand
AdHocConference
Transfers all calls for the specified endpoint to the configured ad hoc conference.
Registration(r): <1..3750>
The index of the registration to be transferred.
AllowListAdd
Adds an entry to the Allow List.
Pattern(r): <S: 1, 60>
Specifies an entry to be added to the Allow List. If one of an endpoint's aliases
matches one of the patterns in the Allow List, the registration will be permitted.
AllowListDelete
Deletes an entry from the Allow List.
AllowListId(r): <1..2500>
The index of the entry to be deleted.
Boot
Reboots the system.
This command has no parameters.
CallTransfer
Transfers the specified call from one call party to the endpoint specified by the supplied
alias.
Call(r): <1..900>
The index of the call to be transferred.
Leg(r): <1..2>
The index of the call leg to be transferred.
Alias(r): <S: 1, 60>
The alias for the call to be transferred to.
CheckBandwidth
A diagnostic tool that returns the status and route (as a list of nodes and links) that a call of
the specified type and bandwidth would take between two nodes. Note that this command
does not change any existing system configuration.
Node1(r): <S: 1, 50>
The subzone or zone from which the call originates.
Node2(r): <S: 1, 50>
The subzone or zone at which the call terminates.