Filter
Top Products
TANDBERG Gatekeeper/Border Controller API User Guide
D14172.01 page 43 of 84
Authentication Database: <LocalDatabase/LDAPDatabase>
Selects between a local database and a remote LDAP repository for the storage of password
information for authentication.
Authentication LDAP BaseDN: <S: 0, 255>
Specifies the Distinguished Name to use when connecting to an LDAP server.
Authentication LDAP AliasOrigin: <LDAP/Endpoint/Combined>
Determines which aliases (i.e. from the LDAP database or the endpoint) should be used to
register the endpoint. Combined: the endpoint will be registered both with the aliases which it
has presented and with those configured in the LDAP repository.
Authentication Credential [1..2500] Name: <S: 0, 25>
Defines the name for this entry in the local authentication database.
Authentication Credential [1..2500] Password: <S: 0, 25>
Defines the password for this entry in the local authentication database.
Zones DefaultZone HopCount: <1..255>
Specifies the hop count to be used when sending an alias search request to a system that is
not configured as a neighbor zone or traversal zone.
Zones Zone [1..100] Name: <S: 1, 50>
Assigns a name to this zone.
Zones Zone [1..100] Gatekeeper [1..6] Address: <S: 0, 128>
Specifies the IP Address or FQDN of this neighbor.
Zones Zone [1..100] Gatekeeper [1..6] Port: <1..65534>
Specifies the port on the neighbor to be used.
Zones Zone [1..100] HopCount: <1..255>
Specifies the hop count to be used when sending an alias search request to this zone.
Note: If the search request was received from another zone and already has a hop count
assigned, the lower of the two values will be used.
Zones Zone [1..100] Monitor: <On/Off>
If zone monitoring is enabled, an LRQ will be periodically sent to the zone gatekeeper. If it
fails to respond, that gatekeeper will be marked as inactive.
Zones Zone [1..100] Match [1..5] Mode: <AlwaysMatch/PatternMatch/Disabled>
Determines if and when a query will be sent to this zone. Always: the zone will always be
queried. Pattern: the zone will only be queried if the alias queried for matches the
corresponding pattern. Disabled: the zone will never be queried.
Zones Zone [1..100] Match [1..5] Pattern String: <S: 0, 60>
(Applies only if the Match mode is Pattern Match.) Specifies the pattern against which the
alias is compared.