Filter
Top Products
65
D13898.05
DECEMBER 2007
TANDBERG CONTENT SERVER
ADMINISTRATOR GUIDE
Table of
Contents
Disclaimers,
Patents etc.
Safety,
Environmental
Introduction Installation Quick Setup Operation
Backup and
Restoring
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
Once you have successfully completed the
basic setup, you can use the multicast
delivery server you have configured and
select it in the Live Media Server Settings
section of your templates.
Basic Setup—It Only Needs to Be Done Once
Prerequisites
Setting up Multicast Delivery
Before you can start
delivering your live content as
a multicast stream you need
to check that:
Your network is multicast-
•
enabled.
The IP address under
•
Destination multicast IP
address and port is correct
and modify it if necessary.
You have congured a
•
multicast delivery server.
Verify the IP address
under Destination
multicast IP address.
Remote Desktop into
your Content Server
and choose Manage
Your Server from the
Start Menu.
Click on Manage this
streaming media
server.
Expand the list next
to the name of your
streaming media
server, then expand
the list of Publishing
Points.
Select the
TCSmulticastTemplate
Publishing Point and
click on the Properties
tab.
Select Category
Multicast streaming.
Right-click on WMS Multicast Data
Writer and select Properties from
the drop-down menu. Verify that
the IP address under Destination
multicast IP address and port is
correct and modify it if necessary.
Please note that the Content
Server will use the rst two
octets of the IP address, but it
will dynamically assign the last
two octets, eg. if an IP address
like 10.0.1.1 is specied, TCS
may use any addresses in
the 10.0 range for multicast
streaming. If all your multicast
streams originate from a Content
Server, you may pick an IP range
when you set up your multicast
network, and tie it to the TCS.
Configure a multicast delivery server:
Go to Administrator Settings > Media Servers to add a Windows Media Streaming
Server and congure it as follows:
Enter a descriptive name for the server
•
Enter ‘(local)’ in the Address eld
•
Select
•
Support Live Streaming
Select
•
Server push
Enter
•
8080 in the Port eld
Publishing Points
•
: Select Create new using settings from existing and enter
TCSmulticastTemplate in the Main and Dual elds
Live URLs:
•
Select
•
Use alternate live URLs and enter http://(local)/tcs/data in the Main and
Dual elds.
Select the checkboxes to have le names appended to the URL
•