Filter
Top Products
- 25 -
New error message “Can’t Verify TapeMode to Non-Destr"
Due to the nature of a TapeMode project, certain bits will change when the project is copied from
one disk format to another. Therefore a verify request on a SmartCopy of a Tape Mode project
will display this error message, because the copy is being performed from one file format to
another.
Below is a table of "to" and "from" Tape Mode project formats that will "retain" a project's Tape Mode
status.
HFS HFS
HFS+ HFS+
FAT-32 FAT-32
.BU .BU
HFS+ FAT-32
HFS+ .BU
FAT-32 .BU
HFS .BU *****
***** If a Tape Mode project is backed up from an HFS disk to a .BU format DVD or tape, it must be
restored onto an HFS disk to retain its Tape Mode status. During such copies, a verify request will be
ignored.
New error message "Zero Length Edit"
In previous versions, the software would allow the selection of two edit points that were the same
time value, creating an edit of "zero length". Attempting to copy or paste a "zero length edit" has
o meaning.
n
If an attempt is made to copy a region that contains a length of zero, the display will then read
"Zero Length Edit".