Filter
Top Products
or
> Press the numeric key “0” to go to the PVR navigator.
Press Back to return to the table “Next”.
7.14.7 SFI functions
To utilise the following SFI functions, call up the SFI as des-
cribed in Point 7.14.3.
7.14.7.1 SFI Info
The function SFI Info allows you to display a biref informa-
tion on the programme or channel selected. Where SFI infor-
mation is available, this will be indicated by the symbol
next to the appropriate programme.
> Use the arrow keys or the function keys to mark
the desired programme.
> Press SFI to display the information.
You can scroll or page through lengthy texts by means
of the arrow keys.
> Press Back to revert to the previous table.
7.14.7.2 SFI timer programming
The electronic programme guide SFI can be utilised to facili-
tate easy programming of timer events.
> Use the arrow or the function keys to mark the
desired programme.
> Press the Record key to programme a Hard drive
timer (see Point 7.15.1.2) for the selected program-
me.
or
> Press the red function key Timer to open a selection
window.
> Use the up/down arrow keys to select the desired
Timer type (see Point 7.15.1.2).
> Confirm by pressing OK.
For monitoring purposes, the menu Timer manage-
ment will be displayed, showing the data related to
the programme selected. Here you can enter any
changes, if required (see 7.15.1.2).
> Press Back to revert to the previous table.
The appropriate line has been marked. Depending on
the timer type, your receiver will now be switched on
at the starting time of the selected programme. If the
unit has been switched on by the PVR timer, this will
be indicated by
“! PVR Timer” shown in the display. Most of the
remote control functions are disabled to prevent an
accidental premature interruption of the recording.
When the unit is in standby mode, an active timer will
be indicated by a clock symbol shown next to the time
on the display.
31
Bed_anl_.qxd 20.02.04 16:28 Seite 31