Filter
Top Products
timer).
Repeat
> Use the arrow keys to mark the column Rep.
> Press OK.
A selection window will be opened, showing various
suggestions for repeats.
1x Timer on once
T Daily repeat
1 W Repeat once a week
1-5 Repeat only on workdays
6-7 Repeat only on weekends
> Use the up/down arrow keys to select the desired
function.
> Press OK to accept the setting into memory.
Accepting data into memory
> When you have completed the programming, press
the yellow function key Accept, to accept the data
into memory.
If under the heading Programme you have selected
a programme that is blocked in terms of Point 8.3, you
will first have to enter the PIN code before the data
will be accepted into memory.
> Press the TV/Radio key to revert to normal opera-
tion.
Timer overview
The timer overview allows you to see at a glance all the timer
events already programmed.
> First call up the menu Timer management as des-
cribed above to go to the menu Timer overview.
> Use the up/down arrow keys to mark the line
Timer overview.
> Confirm by pressing OK.
If there are overlaps between timer events, these over-
laps will be highlighted in red.
Changing timer programming
> To change an existing timer setting, use the up/down
arrow keys to mark the timer event you wish to
change.
> Press the yellow function key Change to go to the
settings of the marked timer. Proceed to make the
changes as set out in Point 7.15.1.2.
> When you have completed the programming, press
the yellow function key Accept to accept the data
into memory.
Deleting timer programming
> To delete an existing timer setting, use the up/down
arrow keys to mark the setting.
37
Bed_anl_.qxd 20.02.04 16:29 Seite 37