Filter
Top Products
rected as described under Point 8.3.4 (manual programme
scan). The current transponder data may be obtained from
your specialist retailer. In the normal course of events you
should not make any changes to this menu.
Note:
This function should not be implemented if you
have made changes in the menues “Basic set-
tings” or “LNC configuration”, as these settings
will revert to the factory default settings, and the
desired changes will have to be entered again.
For the new software to be downloaded automati-
cally, the digital receiver must be in standby
mode. The download procedure will be indicated
on the display by “SAtL”. Do not interrupt this
procedure, e.g. by switching the receiver on or
off.
Independently of whether you have set the automatic soft-
ware update function to On of Off, each time you switch on
the receiver the system will check whether a new version of
the operating system software for your digital receiver is avai-
lable. If a new version of the operating software is available,
this will be indicated by a message shown on screen (Fig. 8-
24).
To start the update of your software, follow the instructions
displayed on your screen.
8.5.4 Copying the settings
You have the facility to copy all the settings of your digital
receiver (transmitter), such as programme lists, antenna set-
tings, etc. to another digital receiver (receiver) of the same
type, and equipped with the same version of the operating
system software. (Fig. 8-25)
> To do this, connect the two units by means of a null
modem cable.
> Switch on the (receiving) receiver.
> To copy the settings, press any key on the (transmit-
ting) receiver.
The settings of the transmitting receiver will now be
transmitted to the receiving receiver. Please not any
messages displayed on screen.
8.6 System configuration
This menu item will show you the specific unit data, e.g. cur-
rent software version.
> Use the up/down arrow keys to mark this line in
the sub-menu Settings.
> Confirm by pressing OK.
> Press the Menu key to revert to normal operation.
8.7 Encryption system
55
(Fig. 8-13)
(Fig. 8-14)
Bed_anl_.qxd 20.02.04 16:29 Seite 55