Filter
Top Products
E-DOC-CTC-20061027-0003 v2.0
IP Commands
437
EXAMPLE:
addrcheck Set the level of IP address checks.
Choose between:
> off: No address checking is performed. For advanced users only;
in normal circumstances there should always be some kind of
address checking.
> own: Minimum level of checking.
Only the address configuration on the Thomson ST is checked.
> static: Checking of the address configuration of the Thomson ST
and also of traffic: addresses of incoming packets; this checking
is related to constants (for example an address may not be
entirely composed of one‘s or zero‘s).
> dynamic: Besides the address configuration of the Thomson ST
itself, and besides the checking of traffic on a constants level,
additional checking is performed on the IP addresses that are
determined by the configuration, more specifically by the
network.
The default is dynamic.
OPTIONAL
mssclamping Disable or enable mss clamping for low MTU interfaces.
Enabling mss clamping assures that the size of a TCP packet never
exceeds the available Maximum Transmission Unit (MTU) of the
outgoing interface.
The default is on.
Note It is recommended not to disable this parameter.
OPTIONAL
natloopback Disable/Enable NAT loopback.
The default is enabled.
OPTIONAL
loadbalancing Select loadbalancing mechanism OPTIONAL
bitrate-
window(sec)
A number between 10 and 3600.
Set the window to calculate the bitrate (multiple of 10).
The default is 30.
OPTIONAL
acceleration Disable/Enable IP acceleration OPTIONAL
=>ip config
Forwarding enabled
Sendredirects enabled
IP options enabled
NetBroadcasts disabled
Default TTL 64
Fraglimit 64 fragments
Fragcount currently 0 fragments
Defragment mode : enabled
Address checks : dynamic
Mss Clamping : enabled
NAT Loopback : enabled
Bitrate window (sec), multiple of 10 : 30
=>