Filter
Top Products
11
8. Daylight Saving Time (DST)
The DST setting (2007 forward) is as follows: The starting time is 2:00 AM on
the second Sunday in March. The ending time is 2:00 AM on the first Sunday
in November. The Atomic Synchronization will adjust the T100 automatically
for Daylight Saving Time.
•
Press <AM IN> once to set DST
(press <AM IN> 7 times if just entering
programming mode).
The display reads “
dS
On
”.
•
Press <OT IN> to toggle between On and Off.
•
Press <OT OUT> to save.
If you do not desire Two-Color Printing or Signal Tones you
should exit programming mode by sliding the programming
switch to “Normal”.
9. Inputting the Default Password
Input the default password to set Two-Color Printing or the Signal Tone.
•
Press <AM IN> once
(press <AM IN> 9 times if just entering programming
mode).
The display reads “
00 00
”.
• The default password is “1234”.
Press <AM OUT> to advance the first digit.
Press <PM IN> to advance the second digit.
Press <PM OUT> to advance the third digit.
Press <OT IN> to advance the fourth digit.
•
Press <OT OUT> to input the password and enter into Two-color Printing
set-up.
Note: An “E-40” error code means the password was incorrect. It was
either entered incorrectly or the default password
(“1234”) has
already been changed (see pg 15 for resetting the password).
Once you enter the password, it remains in effect until exiting
programming mode.