5
IV. Quick Setting the T100
The Atomic Synchronization allows you to utilize the simple steps below to
set the T100.
Default Settings
Time Zone – Eastern Standard Time
Pay Period – Weekly
Daylight Savings – Automatic
Note:
There are many additional options with the T100 outlined on Page 6.
If you desire any of these options, proceed to the appropriate section for
programming.
Setting
• Plug transformer into the bottom of the T100 and plug in transformer
•
Move switch on the rear to “Program”.
• Push <AM-IN> 6 times. Display will appear like:
• Press <PM-OUT> to select your time zone.
•
Press <OT-OUT> to save Time Zone setting.
• Leave Timex T100 plugged in overnight. In the morning the “Atomic
Time Synchronization Indicator” should be visible and the time and
date will be set.
•
Take a test print; if the print is satisfactory proceed to “Operating the
T100” on page 17.