Filter
Top Products
22
Location of fuses
The fuse panel is located on the back of the T100 in the lower left corner. To
access fuses, disconnect the power from the clock and remove the screw that
secures door. Replace blown fuse with only the same rated fuse. Do
not
substitute.
1. Printer Head Fuse (1.5A DC 12V)
2. AC Fuse (1A AC 240V)
3. DC Fuse (2A DC 12V)
Error Codes
The T100 has built-in diagnostics to guide you in maintaining your time clock.
These Error Codes, when occurring, will be seen on the display.
Code Meaning of Error Check
E-01 Clock motor or sensor failure Unplug and reconnect power
cord or turn the program switch
on-off twice, letting the clock
readjust.
E-03 Card positioning Verify correct card (T111)
E-05 Card does not feed correctly Verify correct card (T111)
Re-insert card.
E-30 Printer head fails to return to
home position
Contact dealer or Service Center
E-33 Can’t change color Check that the ribbon is
installed correctly.
E-35 The card can’t be returned Make sure there are no
obstructions in card receiver
E-37 Sensor cannot locate card Contact dealer or Service Center
E-38 Printer head jammed Remove ribbon and check for
binding. Reinstall ribbon.
E-40 Wrong password entered Enter the correct password or
refer to section “Setting the
Password”.