Filter
Top Products
16
13.
Changing the Default Password
The T100 uses a four-digit password to protect programmed settings. Note:
once the password is set you will be asked to enter it each time you enter
the programming mode. If you set a new password you should write it
down and store it in a safe place.
Note: If a new password is lost it can be reset to the default”1234” by
simultaneously pressing and holding
<AM IN>
&
<AM OUT>
buttons for 10
seconds. This will allow access to the clock’s functions without resetting the
current programming. If you wish to reset the programming and password
to factory defaults press the
<RESET>
button on back of clock with the
programming switch set to
“NORMAL”
mode.
• Press <AM IN> once. “12 34” is displayed.
(If entering programming
mode begin at “Inputting the Default Password” section & continue to
this step).
Press <AM OUT> to advance the first digit.
Press <PM IN> to advance the second digit.
Press <PM OUT> to advance the third digit.
Press <OT IN> to advance the fourth digit.
• Press <OT OUT> to save the password.
Important: Write the new password here
Once the password has been set the T100 will display “
0000
” each time you
enter the programming mode. The password must be entered and
<OT OUT> pressed to enter program mode. If the password is incorrect, the
T100 will beep and Error Message “
E-40
” is displayed. You will not be
allowed to enter the programming mode until the correct password is
entered.
Exiting Program Mode
When finished programming the T100, slide the program switch to the
“NORMAL” position. Note: The clock will not function unless you exit
Programming Mode by sliding the Programming Switch to “NORMAL”.