Filter
Top Products
24
1.BEFORE USING EQUIPMENT
1.Description of Each Component (Cont.)
1
8. Slot Cover
This cover is used when the 2nd Drawer is not installed. (e-STUDIO202L only)
9. Saddle Stitch Finisher (MJ-1025)
This finisher enables saddle stitching, in addition to sort/group finishing and stapling. (The Hole Punch
Unit sold separately can be installed to this finisher.) The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
10. Hanging Finisher (MJ-1022)
This finisher enables sort/group finishing and stapling. The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
11. Hole Punch Unit (MJ-6005)
This unit enables you to punch holes on printouts. It can be installed to the Saddle Stitch Finisher
(MJ-1025).
12. Automatic Duplexer
Enables duplex copying.
Standard on the e-STUDIO232/282.
Other options available are as follows. Contact your service technician or Toshiba product distributors for
details.
Work Table (KK-3511)
This is a small table for placing originals while the equipment is operated.
• This cannot be installed with the e-BRIDGE ID Gate.
FAX Unit (GD-1150)
This is a unit for using the equipment as a Fax.
• Installed inside of the equipment
2nd Line for Fax Unit (GD-1160)
This unit enables to add a line to the Fax to make it 2nd line.
• Installed inside of the equipment
• The Fax Unit (GD-1150) is necessary.
Desk (MH-1700)
This is a desk for the equipment.
Data Overwrite Kit (GP-1060)
This is a kit to erase the data stored temporarily when copying, printing, scanning, Fax, internet Fax or net-
work Fax is performed. It overwrites temporarily stored data with random data.
• Installed inside of the equipment
Scrambler Board (GP-1040)
This board enhances the security of the equipment. Data are encrypted when they are written into the hard
disk of the equipment, and decrypted when they are read.
• Installed inside of the equipment
• The PCI Slot (GO-1060) is necessary.
Wireless LAN Module (GN-1041)
This module enables the equipment to be used in a wireless LAN environment.
• Installed inside of the equipment
• The Antenna (GN-3010) is necessary.
• The equipment cannot be connected to the wireless and wired LAN at the same time.