Toshiba 282 All in One Printer User Manual


 
68
2.HOW TO MAKE COPIES
2.Making Copies (Cont.)
2
5
Place the next original, and press the [START] button.
Data scanning of this original starts.
The next original will also be scanned in the same manner when you press the [YES] button on the touch panel
and then press the [START] button on the control panel.
Repeat the above procedure until the scanning of the last page of the original finishes.
6
When scanning of all pages has finished, press the [FINISHED] button
on the touch panel.
Copying starts. The paper exits with its copied side down.
When the drawer runs out of paper during copying, the corresponding drawer on the touch panel and the [JOB
STATUS] button on the control panel blink. Add paper to this drawer or select another one with the same paper
size.
Be careful because the paper exit area and paper just after exiting are hot.
4
Press the [START] button.
Copying starts.
When you copy by placing originals on the original glass (e.g.
using the sort mode, or making 1-sided original 2-sided copies),
the data of these originals are scanned into the memory. In this
case, proceed to steps 5 and 6.