Filter
Top Products
24
1.BEFORE USING EQUIPMENT
1.DESCRIPTION OF EACH COMPONENT (Cont.)
1
9 : PRINT DATA/MEMORY RX/FAX communication
If these lamps light, they show the status of receiving data, receiving original(s) standing by to be printed
and currently used telephone line (1 or 2).
10: [INTERRUPT] button
Use this button to interrupt the copying job in process and to perform another copying job.
You can resume the interrupted copying job by pressing this button again.
11: [JOB STATUS] button
Use this button to confirm each status of print or scan or Fax, and journal for TX or RX of Fax.
"1.JOB STATUS" Page 186
12: [ACCESS] button
Use this button when the department codes have been set.
If this button is pressed after copying, the next user cannot use the copy function without keying in the
registered department code. (See the [User Functions Guide].)
13: [ENERGY SAVER] button
If you are not going to use the equipment for a while, press this button. The equipment enters the energy
saving mode and all the display lamps are turned off.
14: [FUNCTION CLEAR] button
When this button is pressed, all selected functions are cleared and returned to the default settings.
"3.GENERAL COPYING PROCEDURES" Page 52
*Automatic Function Clear
Even if you do not press the [FUNCTION CLEAR] button, within the specified period of time after copying
is finished or after the last button is pressed in a copy procedure, the automatic function clear mode will
clear all settings to defaults, and the basic screen will be displayed. While the department management
function is being operated, the display returns to the access code input screen.
15: [STOP] button
Use this button to stop an ongoing scan and copy operation.
16: [START] button
Press this button to start copying, scanning and Fax operation.
17: Digital keys
Use these keys to enter the number of copies you want to make and so on.
18: [CLEAR] button
Use this button to correct numbers entered with the digital keys such as an incorrect copy quantity.
19: ERROR lamp
ERROR lamp lights in red when an error occurs and the equipment needs some actions.
20: [MONITOR/PAUSE] button
This button is used when the copier is used as a Fax (optional). (See the [Operator’s Manual for Facsimile
Function] for detail.)
21: Touch Panel
The state of a copier and directions for its operation are expressed as characters and illustrations.