Filter
Top Products
e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-23
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(5) Finely adjust the rotating speed of the registration motor, in accordance with a pattern for the out-of-
registration colors.
• Use steps (a) to (b) to perform the adjustment.
(a) Enter adjustment mode [05]. Select code [483]. Finely adjust the rotating speed of the registration
motor.
• Adjust the values in accordance with a pattern for the out-of-registration colors as shown in the
table below.
Pattern for
out-of-
registration
colors
[05] code Subcode Recommended value
Acceptable
value range
Default
Pattern A
123 to 127
(Set a value smaller than 128)
Pattern B
05-483 0
129 to 132
(Set a value larger than 128)
0 to 255 128
(b) After performing registration control, print out the test print pattern to check whether the misaligned
colors have been improved.
* For further information regarding the adjustment procedures, refer to procedures (3) and (4).
* Repeatedly use procedures (3) to (5) as necessary, to select a proper value.
<Hint> When subcode "0" is adjusted for code 05-483, the correlation between the paper feeding speed
and rotating speed of the transfer belt will be corrected in every paper mode. However, when
colors are misaligned on an image printed in the thick paper mode after the adjustment for
subcode "0", adjust subcode "3" (during deceleration in the thick paper mode).
* For subcode "3," use the steps and recommended values for subcode "0."
* Paper for printing a test print pattern will only be fed from the drawer. Load the desired
number of sheets of thick paper in the drawer, in order to print the test print pattern on thick
paper.
* Adjust subcode "0" and then subcode "3," in order to adjust only misaligned colors in the thick
paper mode.