Filter
Top Products
e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-33
2. Copier-specific Adjustments
(3) Enter adjustment mode [05]. Change the values for codes [7033], [7034], [7041] to [7044], [7048] and
[7049] to adjust the density level of the background.
Adjustment Original mode [05] code
Recommended
value
Accep
table
value
range
Default
Text/Photo 05-7041
Text 05-7042
Photo 05-7048
Manual density
adjustment
Image smoothing 05-7049
Text/Photo 05-7033
Text 05-7034
Photo 05-7043
Manual adjustment
Image smoothing 05-7044
Set a value smaller
than 128.
0 to
255
128
* Set the value in increments of approximately 25, while checking the copy image until the optimum value is
obtained.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(4) Enter the adjustment mode [05]. Change the values for codes [7286] and [7287] to make the range
correction operation in the manual density mode fixed.
• The code to be set differs depending on the original mode (Text/Photo or Text). Select the [05] code for the
target original mode and change the value to "0".
Original mode [05] code
Recommended
value
Acceptable
value range
Default
Text/Photo 05-7286
Text 05-7287
0 0, 1 1
* Explanation for setting values
Setting
value
Range correction
operation
0 Fixed
1 Varied
After adjusting the background peak, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.