Filter
Top Products
TOSHIBA 6F3A4508
- 2 -
[1] Introduction
This document describes the Wi Tool which is a tool for the Toshiba Wi Series drive equipment.
For information on how to install Wi Tool on your PC, refer to the "Installation manual"
(6F3A4507). Note that the drive equipment cannot be connected unless the correct connection
method and PC settings are used. Be sure to understand the concept of these settings
thoroughly.
The following topics are described:
Chapter 2: Connection Method
Chapter 3: Startup Method
Chapter 4: Main Window Description
Chapter 5: Function Summary
Chapter 6: Function Details
Chapter 7: Connection Other than 1:1 Connection
<Before you begin>
Microsoft and Toshiba have the Copyrights to this software. Copying this software to
unauthorized PC is prohibited.
Do not install programs other than the above on your PC. The settings of your PC may be
altered causing the Wi Tool to slow down or become inoperable.
<Notes on rewriting drive equipment data>
Observe the following when rewriting the drive equipment data.
1) Rewriting the data may disturb the drive equipment. (For example, if the speed setting is
rewritten, the motor speed will change. If the control gain is rewritten, the control system will
change causing it to trip or become unstable. ) Be very careful when rewriting. When the motor
is running, the message "OK to rewrite while running?" appears on the screen.
2) When rewriting the data, there is a password function on the drive equipment side. If the
correct password is not provided, a password error occurs and the data remains unchanged.
3) The setting in the drive equipment is normally written in RAM. Wi Tool normally modifies this
data in RAM. However, this data in RAM is erased once the power is turned off. Therefore, the
drive equipment also holds the settings in EEPROM which is not erased when the power is
turned off and the settings are copied to RAM from EEPROM when the power is turned on.
When data is changed with the Wi Tool, only the data in RAM is changed. Therefore, the
settings must be copied from RAM to EEPORM before turning the power off.
<Maintenance>
This software is supplied on CD-ROM. Keep it as backup.