Filter
Top Products
4 Replacement Procedures 4.7 Slim select bay module
4.7 Slim select bay module
Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-9 and 4-10.)
The explanation and figure shown below indicate the optical drive removing/installing.
CAUTION: Do not put fingers in the slim select bay slot. It may cause injury.
1. Remove the following screw securing the latch.
M2.54.0B FLAT HEAD screw 1
2. Set the removed screw into the screw hole. (The slim select bay is unlocked.)
3. While sliding the latch toward the arrow direction in the Figure 4-10, push the hook
of the slim select bay module and pull out the slim select bay module to disconnect it
from the system board.
Screw hole
Latch
Hook
M2.54.0B FLAT HEAD
Slim select bay module
Figure 4-9 Removing the slim select bay module
4-20 [CONFIDENTIAL] PORTÉGÉ M780 Maintenance Manual (960-809)