Filter
Top Products
3-4
EM18-33010A
3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
Fig. 3-5
Fig. 3-6
3.2 CUTTER MODULE (B-4205-QM)
7. Install the cutter unit with the attached screws (cutter attaching screw, FL-4x6).
When installing the cutter, make sure that the cutter guide is not in contact with the platen. If it is, print
failure or noise may be caused.
8. Remove the motor cover. (See Fig. 2-9.)
9. Disconnect the connector from CN2 on the PWM PC board.
Clamp and pass the cable through the opening and connect it to the CN1 on the Cutter I/F PC board.
Clamp
CPU PC Board
Connector (CN2)
PWM PC Board
Opening
Cable
Cut I/F PC Board
Cutter Unit
Connector (CN2)
SVO7A1003: Nov. 21 ’97