6-53
EM18-33010A
6. DIAG. TEST OPERATION
Function
If you enter the RAM clear mode by mistake, specify this mode to
escape from the RAM clear mode without executing RAM clear.
After replacing the print head, cutter module, ribbon feed/rewind
motor, solenoid and CPU PC Board, clear the maintenance counter.
The following data will be cleared to zero. Confirmation can be made
through the maintenance counter procedure in self test mode.
(See NOTE 1 and 2.)
This clear should be employed when initializing the following
parameters to the settings before shipment. Confirmation can be
made through the automatic diagnostic procedure in self test mode.
(See NOTE 1 and 2.)
Mode Name
NO RAM CLEAR
MAINTE. COUNTER
CLEAR
PARAMETER CLEAR
metIeulaVlaitinI
derevocecnatsidaideMmK0.0
ecnatsidtnirPmK0.0
tnuoctuCsemit0
tnuocnwoddnapudaeHsemit0
emitgnivirdrotomnobbiRsruoh0
emitgnivirddioneloSsruoh0
tnuocrorreerawdrahC232-SRsemit0
tnuocrorremetsySsemit0
tnuoceruliafrewopyratnemoMsemit0
6.6 RAM CLEAR MODE
In RAM clear mode, various data written on the EEP-ROM can be initialized. There are two clear
functions; Maintenance counter clear and parameter clear in the parameter setting mode. After
referring to the following table specify and clear or initialize the data.
■ RAM Clear Mode Table
metIeulaVlaitinI
)CP(tnemtsujdaenifhtgneldeeFmm0.0
)CP(tnemtsujdaenifnoitisoppirts/tuCmm0.0
)CP(tnemtsujdaenifhtgneldeefkcaBmm0.0
tnemtsujdaenifenottnirP
)CP()refsnartlamrehT(
pets0
tnemtsujdaenifenottnirP
)CP()tceridlamrehT(
pets0
)YEK(tnemtsujdaenifhtgneldeeFmm0.0
)YEK(tnemtsujdaenifnoitisoppirts/tuCmm0.0
)YEK(tnemtsujdaenifhtgneldeefkcaBmm0.0
tnemtsujdaenifenottnirP
)YEK()refsnartlamrehT(
pets0
6.6 RAM CLEAR MODE