Filter
Top Products
6-6
EM18-33010A
6. DIAG. TEST OPERATION
NOTES: 1. If the automatic diagnosis printing results in an error, the printer will display the error
message and stop printing. The error status can be cleared by the [PAUSE] key,
however, the display will return to the initial display “<1> DIAGNOSTIC V1.0A”.
Printing is not automatically resumed.
2. Both label and tag paper can be used for printing.
(Revision Date Jan. 13, ’95)
6.2 SLEF TEST MODE
6.2.2 Automatic Diagnostic Printing
The data from 1 to 9 on a sample print is printed.
<
1 DIAGNOSTIC V1.0A
>
Power off
C
H CKING & PRINTINGE
A
U OMATIC DIAGNOSTICT
R
I BON TRANSMISSIVEB
Select the ribbon type from those
at the right by pressing the
[FEED] key or [RESTART] key.
Press the [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key.
The printer is checking or printing
the status
The result of the self test
is printed. After printing,
the initial display will be
shown.
NO RIBBON (No ribbon : Thermal direct)
TRANSMISSIVE
(Transmissive ribbon : Thermal transfer)
NO TRANS.
(Non-transmissive ribbon : Thermal transfer)
Press the [PAUSE] key.
Continued on Section 6.2.3
Head Broken Element Check.
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [PAUSE] key.