Filter
Top Products
6-42
EM18-33010A
6. DIAG. TEST OPERATION
6.4 TEST PRINT MODE
Set the print speed
Set the print count from those at the
right by pressing the [FEED] key or
[RESTART] key. (See NOTE 2.)
Select the print speed from those at
the right by pressing the [FEED]
key or [RESTART] key.
Select the sensor type from
those at the right by pressing
the [FEED] key or [RESTART]
key. (See NOTE 2 and 4.)
Select the ribbon type from
those at the right by pressing
the [FEED] key or [RESTART]
key. (See NOTE 2, 5 and 9.)
Press the [FEED] key
and [RESTART] key
at the same time.
Press the [PAUSE] key. (See NOTE 3.)
Press the [PAUSE] key. (See NOTE 3.)
Press the [PAUSE] key. (See NOTE 3.)
Press the [PAUSE] key. (See NOTE 3.)
PR NT SPEED 5inch/sI
SE SOR TRANSMISSIVEN
From B of the preceding page.
To C of the
preceding page.
Press the [FEED] key
and [RESTART] key
at the same time.
To C of the
preceding page.
Press the [FEED] key
and [RESTART] key
at the same time.
Press the [FEED] key and
[RESTART] key at the same
time.
To C of the
preceding page.
To C of the preceding page.
To be continued on
B of the next page.
Set the sensor type
RI BON TRANSMISSIVEB
Set the ribbon type
5000 (Print count 5000)
1000 (Print count 1000)
500 (Print count 500)
100 (Print count 100)
50 (Print count 50)
10 (Print count 10)
5 (Print count 5)
3 (Print count 3)
1 (Print count 1)
3 inch/sec.
NONE
(consecutive form)
REFLECTIVE
(black mark sensor)
TRANSMISSIVE
(feed gap sensor)
NO RIBBON
(No ribbon: Thermal direct)
NO TRANS.
(Non-transmissive ribbon:
Thermal transfer)
TRANSMISSIVE
(Transmissive ribbon:
Thermal transfer)
5 inch/sec.
8 inch/sec.