Filter
Top Products
2. PRINTER SETUP
ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-16
2.7 Setting an Operating
Environment
Depending on the settings of your host computer or an interface to be
used, it may be necessary to change the printer parameter settings.
Follow the procedures described below to change the printer parameter
settings in the System Mode to correspond to your environment.
The System Mode consists of the following menus.
<1>RESET This menu is used to clear print data sent from a
PC and return the printer to an idle state.
Refer to Section 3.3 Reset.
<2>PARAMETER SET
This menu is used to set the printer parameters.
<3>ADJUST SET This menu is used to make a fine adjustment of a
print start position, cut position, etc.
Refer to Section 2.10 Position and Print Tone
Fine Adjustment.
<4>DUMP MODE This menu is used to print the data in the receive
buffer for debug.
<5>EXPAND MODE This menu is used to start the program for
BASIC mode.
Refer to the B-SA4T Series Key Operation
Specification stored in the CD-ROM.
NOTE:
I
ncorrect settings can cause the printe
r
to function erroneously. If you
have any problems with the parameter settings, please contact your nearest
TOSHIBA TEC service representative.
F
or the settings this manual does not cover, please contact your nearest
TOSHIBA TEC service representative, or refer to the B-SA4T Series Key
Operation Specification stored in the CD-ROM.
NOTES:
1. System Mode menus can be
selected with the [RESTART]
or [FEED] key.
2. To enter each of the above
System Mode menus, press the
[PAUSE] key when the menu is
displayed.
[FEED]
[FEED]
[FEED]
[FEED]
[FEED]
[RESTART]
[RESTART]
[RESTART]
[RESTART]
[RESTART]
<1>RESET
<2>PARAMETER SET
<3>ADJUST SET
<4>DUMP MODE
<5>EXPAND MODE
ON LINE
PAUSE
[PAUSE]
Hold down [RESTART] for 3 sec.