Filter
Top Products
Appendix 5 System Mode
94
Adjust the X-coordinate.
After entering the value, press the PAUSE key. The message
returns to “<2> PARAMETER SET”.
Adjusting Print Density (K, M, C and Y)
Press the PAUSE key. “POSITION” appears. Press the FEED
key.
Print density adjustments are ready to be set. Press the PAUSE key.
Adjust the print density of black.
After selecting the value, press the PAUSE key.
Adjust the print density of magenta.
After selecting the value, press the PAUSE key.
Adjust the print density of cyan.
After selecting the value, press the PAUSE key.
Adjust the print density of yellow.
After selecting the value, press the PAUSE key.
When the values for all colors are entered, press the PAUSE key.
The message returns to “<2> PARAMETER SET”.
Notes:
• Use the FEED key for lighter
density, or the RESTART key for
darker density.
• The acceptable print density values
are -50 to +50.
• The print density value is +0 at
shipment from the factory.
POSITION
PRINT DENSITY
BLACK -1
MAGENTA +0
CYAN +3
YELLOW +0
X-Coordinate (-99.5mm to +99.5mm)
X ADJUST +50.0mm
X Y Z
-
+
Note:
See A5.7.5 for more detail.
A5.4 Parameter
Setting (Cont.)