Toshiba CB-416-T3-QQ Printer User Manual


 
Chapter 2 Printer Installation
18
2.6.2 Feed Gap Sensor When the media with gaps or rectangular holes is loaded, adjust the
Feed Gap Sensor (transmissive sensor) position as follows:
1
Open the Top Cover.
2
Lift the Pinch Roller Lever to the ROLLER RELEASE position
to open the Pinch Roller Unit.
3
Align the Media Guides to width of the media.
4
Insert the media into the Media Inlet.
If the media with gaps is loaded, go to Step 5.
If the media with rectangular holes is loaded, go to Step 6.
5
Turn the Media Guide Knob, and move the media sensor so that
the gap between labels will pass under the sensor.
Media Sensor
Media Guide Knob
Gap detected here
Sensor
Label
Gap
Backing Paper
Note:
“2” marked on the sensor indicates
the Feed Gap Sensor position.
6
Turn the Media Guide Knob, and move the media sensor so that it
is positioned at the center of the rectangular hole.
Media Sensor
Media Guide Knob
Hole detected here
Sensor
Hole
Media
7
The Feed Gap Sensor Position Adjustment has been completed.
Note:
See A1.3.2 for gap or hole specifications.