Filter
Top Products
Chapter 3 Printing
56
3.6.5 Fine Adjustment
In Fine Adjustment, the following can be adjusted.
First mark the Set checkbox, and the items which can be adjusted
will appear. Depending on the Issue Settings, some of the items
cannot be adjusted. (They are grayed out.)
• In Feed, the print start position can be adjusted.
• In Backfeed, the length of label stock that is fed back before
printing, can be specified. Depending on the type or size of media,
the print start position of ONLY the FIRST label or tag may be
different from what is defined in the Feed fine adjustment. If
there is a difference that is not permissible, adjust the back feed
distance. This adjustment does not have any impact upon the
print start position after the first label or tag.
• In Cut/Strip, the cut position can be adjusted.
Notes:
• See Appendix 5 for further information.
• For back feed and cut/strip fine
adjustments, the Cutter Module
must be installed and enabled.
Note:
The settings made in this section can
be saved in the file as the printing
preferences for a particular print job.
See Section 3.3.4 for more detail.