Toshiba CB-416-T3-QQ Printer User Manual


 
Appendix 1 Specifications
75
A1.2 Options
Name
Cutter Module
Ribbon Module
Model
CB-1204-QM
CB-1004-QM
Description
Rotary cutter for cutting
media without stopping
Spare ribbon module
Please make sure that the media that will be used is approved by
TOSHIBA TEC. The warranty does not apply when a problem is
caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC-approved media, please
contact an authorized service representative.
Two types of media can be loaded for this thermal transfer printer-
label or tag. The table below shows size and shape of the media
available for this printer.
A1.3.1 Media Type
A1.3 Media
Paper Width
Length (Pitch)
Thickness
Max. Roll Diameter
Winding Method
Paper Core
Label Tag
50.4 to 110 mm 50.4 to 110 mm
10 to 1050 (1300) mm 10 to 999 mm
130 to 170 µm 100 to 290 µm
φ230 mm
Rolled outside Rolled inside
ID φ76.2 mm +_ 0.3 as standard
The ratio “Label length” to “Gap length” must be 3:1 or more.
In Cut Mode, the minimum “Pitch” must be 30 mm or more.
The paper width for the label includes its backing paper.
As backing paper, glassine 7K blue or equivalent must be used.
(The backing paper to be used must have a transmission factor of
22% or higher.)
In Cut Mode, the cut should not be performed on the label, but on
the gap between labels. When labels with perforation are used, it
is necessary to test and confirm the cutting performance thoroughly
beforehand.
The gap length must be 6 mm or more, and the cut position must
be adjusted so that the cutter cuts in the center of the gap.
Media Core
Outside Diameter
Label Roll
Diameter
Note:
Labels are rolled outside, and tags are
rolled inside. Whichever media you
use, load it with print side facing up.
The label length (pitch) will be
1300 mm if a SIMM is added to the
printer.
Label
Ta g