Filter
Top Products
Chapter 8. General Settings 58
Clip Hold Time: The number of seconds that the clipping indicator will be visible
after clipping is detected.
Scale: Select whether the peak meter displays linear or logarithmic values. The
human ear perceives loudness on a logarithmic scale. If the Scale setting is
set to Logarithmic (dB) scale, the volume values are scaled logarithmically.
The volume meters of digital audio devices usually are scaled this way. On
the other hand, if you are interested in the power level that is applied to
your headphones you should choose Linear display. This setting cannot
be displayed in units like volts or watts because such units depend on your
headphones.
Minimum and maximum range: These two options define the full value range
that the peak meter displays. Recommended values for the Logarithmic
(dB) setting are -40 dB for minimum and 0 dB for maximum. Recommended
values for Linear display are 0 and 100%. Note that -40 dB is approxi-
mately 1% in linear value, but if you change the minimum setting in linear
mode slightly and then change to the dB scale, there will be a large change.
You can use these values for ‘zooming’ into the peak meter.
Default Codepage: A codepage describes the way extended characters that are not
available within the ASCII character set are encoded. ID3v1 tags do not have a
codepage encoding contained so Rockbox needs to know what encoding has been
used when generating these tags. This should be “ISO-8859-1” but to support lan-
guages outside Western Europe most applications use the setting of your operating
system instead. If your operating system uses a different codepage and you are
getting garbled extended characters you should adjust this settings. In most cases
sticking to “ISO-8859-1” would be sufficient.
8.5 System
8.5.1 Start Screen
Set the screen that Rockbox will start in. Selecting Resume Playback will resume
playback where it was when the player was shut off if there is a playlist to resume and
will then end up in the WPS. Selecting Previous Screen will make Rockbox start in
the screen it was when the player was shut off.
8.5.2 Battery
Options relating to the battery in the player.
Battery Capacity: This setting can be used to tell Rockbox what capacity (in mAh)
the battery being used has. The default is , which is the capacity value for the
standard battery shipped with the player. Rockbox uses this value to estimate
remaining battery life for the info screen and WPS. Changing this setting has no
The Rockbox manual Toshiba Gigabeat F Series