Filter
Top Products
User’s Manual 4-16
Operating Basics
Microphone level
If you have an external microphone connected, you can change the
microphone gain. Follow the steps below.
1. Click start, point to All Programs, point to Accessories, point to
Entertainment and click Volume Control.
2. Click Options and point to Properties.
3. Select Realtek HD Audio Input and enable Recording Control,
Mic Volume and Stereo Mix. Then click OK.
4. Click options and point to Properties. Select Realtek HD Audio
Output and enable Mic Volume and click OK.
5. Click Advanced.
6. Check the Microphone Boost checkbox.
Modem
This section describes how to connect and disconnect the internal modem
to and from a telephone jack.
Region selection
Telecommunication regulations vary from one region to another, so you will
need to make sure the internal modem's settings are correct for the region
in which it will be used.
To select a region, follow the steps below.
1. Click start, point to All Programs, TOSHIBA, Networking, and click
Modem Region Select.
Advanced Controls is a Microphone Boost icon. Once this item is
checked, you will find Advanced icon beside Mic Volume. With this, the
input signal into Mic Volume will be strengthen.
The internal modem does not support voice functions. All data and fax
functions are supported.
■ In case of a lightning storm, unplug the modem cable from the
telephone jack.
■ Do not connect the modem to a digital telephone line. A digital line will
damage the modem.
Do not use the Country/Region Select function in the Modem setup utility
in the Control Panel if the function is available. If you change the Country/
Region in the Control Panel, the change may not take effect.