Filter
Top Products
User’s Manual 7-2
BIOS Setup and Passwords
Password
User Password / Supervisor Password
This option allows you to set or reset the user password for power on.
To enter a user password:
1. Enter a password of up to 10 characters. The character string you
enter is displayed as a string of asterisks. For example, if you enter a
password consisting of four characters, the display is shown as:
Enter Password: ****
2. Click the ENTER button. The following message appears, allowing
you to verify the password.
Verify Password:
3. If character strings match, the password is registered click OK button.
If they do not match, the following message appears. You must repeat
from step 1.
Passwords are not the same Press ENTER to
continue!!!
If you enter the password incorrectly three times in a row, the computer
need to shut off. You will not be able to access the password option in the
BIOS Setup Menu. In this case you must turn the power off and back on to
retry the procedure.
Boot Priority
Boot Priority Options
This option sets the priority for booting the computer.
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. Use the up/down cursor keys to select boot device you want and
press ENTER.
■ If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in BIOS Setup Menu.
USB
Legacy USB Support
When enter BIOS Setup Menu, please choice Advanced item then you can
change or modify the Legacy USB support.