Filter
Top Products
23
Maintenance
Turning the power on and off (Continued)
Turning the power off
1
Press the ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power.
To shut off the power, press the ON/STANDBY button again. If you do not wish to
shut off the power, wait for a while without conducting any operations. The message
will disappear shortly. (This operation is no longer valid after the message disap-
pears.)
2
Press the ON/STANDBY button again.
The screen turns off, but the internal cooling fan continues to operate for a short
while. Then, the projector goes into standby mode.
When cooling lamp
After cooling complete
A B
A
During cooling ,the ON/STANDBY indicator flashes. In this state, the power
cannot be turned back on.
However, there is no problem with unplugging the power cord in this state.
B
In standby mode
Notes
The projector consumes about 0.5W of power in standby. We recommend that you
unplug the power cord if you will not be using the projector for an extended period.
Precaution
If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
Right after turning off the power, the unit may become very hot, especially air exhaust
and the bottom of the unit. Please handle with care to avoid burn injuries.