Filter
Top Products
4.9 SD board/MDC 4 Replacement Procedures
4-34 QOSMIO F10 Maintenance Manual (960-498)
4.9.2 MDC
Removing the MDC
The following describes the procedure for removing the MDC (See Figure 4-20).
1. Turn over the SD board.
2. Remove the following screws fixing the MDC and pull the MDC straight up from the
connector CN3000 on the SD board.
? M2?4Z BIND screw x2
3. Remove the RJ11 harness from the MDC.
Figure 4-20 Removing the MDC
Installing the MDC
The following describes the procedure for installing an MDC (See Figure 4-20).
1. Connect the RJ11 harness to the MDC.
2. Connect the MDC to the connector CN3000 on the SD board.
3. Secure the MDC with the following screws.
? M2?4Z BIND screw x2
MDC
M2?4Z BIND
RJ11 harness
CN30
00