Filter
Top Products
4 Replacement Procedures 4.10 Fan
QOSMIO F10 Maintenance Manual (960-498) 4-35
4
4.10 Fan
Removing the fan
The following describes the procedure for removing the fan (See Figure 4-21).
1. Disconnect the fan cable from the CN8770 on the system board.
2. Remove the following screws and remove the fan.
? M2.5?4B FLAT BIND screw x2
Figure 4-21 Removing the fan
Installing the fan
The following describes the procedure for installing the fan (See Figure 4-21).
1. Install the fan and secure it with the following screws.
? M2.5?4B FLAT BIND screw x2
2. Connect the fan cable to the connector CN8770 on the system board.
NOTE: After connecting the fan cable, put the cable into the space under the system
board.
M2.5x4B FLAT BIND
Fan cable
CN8770
Space