Filter
Top Products
User’s Manual 9-14
Troubleshooting
LAN
Wireless LAN
If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4, Operating Basics.
Recovery discs
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adaptor is connected. The
does not work Wake-up on LAN function
consumes power even when the system is off.
If problems persist, consult your LAN
administrator.
Problem Procedure
Cannot access Wireless
LAN
Make sure the computer’s wireless
communication switch is set to on.
If problems persist, consult your LAN
administrator.
Problem Procedure
The following message
appears when executing
Recovery Disc Creator.
“The Recovery Disc
Creator can not be
launched because there
is no recovery partition.”
You will see this message if you have previously
chosen to remove the partition and are trying to
create “Recovery Media”. When there is no
recovery partition, the Recovery Disc Creator
cannot make Recovery Media.
However, if you have already created a
“Recovery Media”, you can use it to restore the
recovery partition.
Simply follow the instructions in “Restoring the
preinstall software from your creating Recovery
Media” section in this manual. You will be
directed to select “Restore Original Factory
Image” from the drop-down menu. If you have not
created “Recovery Media”, please contact
TOSHIBA support for assistance.